1 to 25 of 38 Ethernet Jobs in the Midlands

etc. Good working knowledge of line protocols, including ISDN/PRI, DID/DNIS, VoIP, SIP, 1DM, Analog, 1.38, DS1/DS3, Metro Over Ethernet, MPLS and Broadband. Experience with Cisco CUCM/Unity/PureCloud Bridge Services/Cisco CUBE, efax. Understanding of TDM and IP voice codecs, including more »

etc. Good working knowledge of line protocols, including ISDN/PRI, DID/DNIS, VoIP, SIP, 1DM, Analog, 1.38, DS1/DS3, Metro Over Ethernet, MPLS and Broadband. Experience with Cisco CUCM/Unity/PureCloud Bridge Services/Cisco CUBE, efax. Understanding of TDM and IP voice codecs, including more »

embedded platforms, with a keen understanding of real-time constraints. A solid background in standard communication interfaces and protocols including RS-232, RS-422, Ethernet, SPI, UART, I2C, and FSK is required. · Hardware Proficiency : Experience with bench test equipment (oscilloscopes, spectrum analyzers, signal generators, etc.) is essential. Candidates should also more »

Proficiency in configuring and troubleshooting network devices at a low level, including switches, routers, firewalls and access points. Knowledge of network protocols such as Ethernet, TCP and IP, VLANs, and routing protocols such as OSPF and BGP. Familiarity with network troubleshooting tools to diagnose and resolve network issues. Understanding of more »

s role is to ensure that these services interoperate and integrate into the customer environment. Such products consist of but not limited to MPLS, Ethernet, IPsec, Managed Security Services, SD-WAN, Managed Hosting and Cloud. The TDA will own the technical delivery of the work-stream in the complex global more »

s role is to ensure that these services interoperate and integrate into the customer environment. Such products consist of but not limited to MPLS, Ethernet, IPsec, Managed Security Services, SD-WAN, Managed Hosting and Cloud. The TDA will own the technical delivery of the work-stream in the complex global more »

required: Embedded C/C++ RTOS Development – ThreadX ideally STM32 Cube IDE IAR tool chain Desirable skills and experience: Python CAN, RS232, RS485, I2C, Ethernet protocols Functional safety standards To be considered for this fantastic opportunity apply with an up-to-date CV today or contact Laurence Powell or Chris more »

/firmware/prototyping/microcontrollers/FPGA/RF/Cadence/MATLAB/USB/System Design/VHDL/BOM/Ethernet/CPU/Bluetooth/DFM/EMC/DSP/Power Electronics/Schematic Design Salary: circa £50k - £70k + benefits Vacancy Location: West more »

commercial proficiency as an Embedded Software Engineer Designing embedded applications in ARM (preferably STM32) Development skills in C and C++ (IAR or KEIL environments) Ethernet, TCPIP, UDP, SPI, RS485, I2C protocols Experience with RTOS (FreeRTOS, ThreadX or similar) Previous designing UI for embedded applications using various graphics engines Understanding of more »

domains, Chassis, Body, Powertrain, Autonomous Drive, Digital Cockpit, Infotainment and Connectivity is desirable. Working knowledge of vehicle networks and diagnostics technologies, CAN, LIN, automotive ethernet, DoIP, UDS/OBD2. Experience using design documentation, and data and network logs to conduct fault finding and root cause analysis. Experience working with CANoe more »

budgetary responsibilities. PLC and HMIsoftware development using at least two manufacturers devices from Rockwell Automation, Siemens, Mitsubishi or Schneider. Experience with multiple communication protocols; EtherNet/IP, PROFINET, PROFIBUS DP and PA, Modbus TCP/IP Experience working with SCADA systems Knowledge and experience in virtual machines (VMWare) Good planning more »

AVR, LoRa) Expertise in debugging and improving complex software systems Experience interfacing with embedded hardware using protocols such as UART, I2C, SPI, RS232, USB, Ethernet Experience with designing, developing and verifying electronic schematics advantageous more »

AVR, LoRa) Expertise in debugging and improving complex software systems Experience interfacing with embedded hardware using protocols such as UART, I2C, SPI, RS232, USB, Ethernet Experience with designing, developing and verifying electronic schematics advantageous Experience with IoT and LoRa would be advantageous The Senior Firmware Development Engineer role requires the more »

Outside of IR35. Key Points: Embedded Linux development in C Knowledge of the Kernel Additional knowledge of communications development (specifically PTP/TSN/Ethernet) would be greatly beneficial Outside IR35 If you'd like to learn more then don't hesitate to reach out! Contract Embedded Linux Developer more »

Outside of IR35. Key Points: Embedded Linux development in C Knowledge of the Kernel Additional knowledge of communications development (specifically PTP/TSN/Ethernet) would be greatly beneficial Outside IR35If you'd like to learn more then don't hesitate to reach out! Contract Embedded Linux Developer - 6 months more »

speed electronics - Proven experience of full life cycle development, including verification and validation, and design for manufacture - Serial comms experience, such as I2C, SPI, Ethernet etc. - A defence/military/aerospace or similar highly regulated background This role will require a minimum of BPSS security clearance. For more information more »

systems utilising PLCs and HMIs. Collaborate with electrical design on control panel designs and schematics. Experience with industrial Bus networks. (Profinet, Profibus, Asi, Industrial Ethernet) Experience with other Automation platforms AB, Mitsubishi, Omron and Schneider and Servo based control. Fault finding on new and existing installations. A successful Senior Control more »

Eplan or AutoCAD Must be totally conversant with PLC control systems. Extensive knowledge of automation architectures and network layers. Extensive knowledge of PROFINET or EtherNET/IP networks for distributed systems. In-depth knowledge of inverters and control wiring, preferably SEW. Experience of designing a control system to a set more »

the Telecommunications space requires an Order Delivery Coordinator to join them on a short FTC basis with a potential for permanent employment. Key Responsibility: Ethernet & Broadband Order placement. Voice and Hosting and Cloud Services Order placement. Validation and Approval of customer order form and requirements for the delivery of the more »

design, development and manufacture Good experience and knowledge of vehicle electrical systems, ECUs and other electrically wired components Working knowledge of CAN, FlexRay, automotive ethernet, LIN networks and vehicle diagnostics. Working knowledge of relevant homologation standards, ISO26262 and EuroNCAP Why work through Contechs? Contechs is a strategic partner to the more »

FTView ME and SE, AVEVA InTouch and System Platform, Schneider ClearSCADA, GE iFIX, Siemens WinCC Telemetry Systems Schneider, Brodersen, Seeprol S2000, Networks - Fibre Optic, Ethernet, Profibus Experience: Good written and spoken communication skills Previous experience as a Control Systems Engineer Full UK driving licence Happy to travel anywhere in the more »

FTView ME and SE, AVEVA InTouch and System Platform, Schneider ClearSCADA, GE iFIX, Siemens WinCC Telemetry Systems Schneider, Brodersen, Seeprol S2000, Networks - Fibre Optic, Ethernet, Profibus Experience: Good written and spoken communication skills Previous experience as a Control Systems Engineer Full UK driving licence Happy to travel anywhere in the more »

and to company standard functions Implementing final commissioning to handover stage Barcoding and interaction with WCS/WMS systems and networks such as Profibus, Ethernet or Asi The Candidate: To be successful in your application for the Controls & Commissioning Engineer role you will need: An Electrical engineering qualification. Experience designing more »

approach. and challenge the sign-off of any new engineering systems requirements from capital projects. Skills/Experience; in Siemens, Allen Bradley, Mitsubishi and ethernet IP. Software engineer with leadership knowledge HMI, motion and communication interface proficiency. or experience CMMS experience, Agility preferred (Desirable). Management Please click ‘APPLY NOW more »

and challenge the sign-off of any new engineering systems requirements from capital projects. Skills/Experience; Experience in Siemens, Allen Bradley, Mitsubishi and ethernet IP. Experienced Software engineer with leadership knowledge PLC, HMI, motion and communication interface proficiency. Knowledge or experience CMMS experience, Agility preferred (Desirable). Project Management more »